Cal Flame Replacement Stainless Steel Grill Burner for G Series and P Series BBQ07100661 Cal Flame

Replacing your Cal Flame Grill burners? BetterPatio is the Number One Authorized Cal Flame dealer in America with the compatible burners you need. This product fits G-Series, P-Series Grills, and Convection Grills with 16″ x 2″ dimensions. Shipped directly from Pomona, CA.

This Cal Flame Stainless Steel Replacement Burner comes with an instruction booklet and it’s very easy to install. As shown below, once your old burner is removed, simply insert, slide and then set your new burner in place. Enjoy the new, clean look with your stainless steel replacement burners!   

Removing Your Cal Flame Burners

The burners can be removed by taking out the locking pins and carefully lifting them up and away from the valve orifice. The locking pins are located under the grill toward the back. They are used to keep the burners in place during shipping and are not necessary to operate your grill.

Replacing Your Cal Flame Burners

Before you replace the burners, inspect the gas valve orifices for cleanliness and condition and the location of the igniters. Set the flame tamers in place before you replace the burners. Carefully insert the burner into the opening for the valve orifice and gently slide it in. Then set the other end of the burner down so the anchor post rests in the hole. When you replace the burners, you don’t need to replace the locking pins.

Staff Tip: If you haven’t used your grill in a few months, we recommend that you clean the burners and the interior of your grill. Cleaning the burners periodically will keep them burning evenly and cleanly and help prevent “flashback”, a type of fire in and around the gas tubes. This happens when spiders and small insects inhabit or make nests in the burner tubes, obstructing the gas flow.

Cleaning Your Cal Flame Burners

Use a wire brush to clean the outer surface of each burner to remove food residue and dirt. Clean any clogged ports with a stiff wire such as an opened paper clip. Make sure the flow channel is clear. The flow channel is the narrow slot on the bottom of the burner near the anchor post. Inspect each burner for damage, such as cracks and holes. If any damage is found, don’t use the grill until you replace the burner.